Rule Rm800b Bilge Pump

Rule-Mate bilge pumps provide ultimate pumping performance, which helps keep your bilge clear of nuisance water, building on the genuine Rule design. Rule-Mate bilge pumps operate using an internal level sensor. When water reaches 2 Inch, the pump will automatically activate, removing water from the bilge. When the water level reaches 3/8 Inch the pump will turn off until the water level rises again. Bilges are not always clean and free from debris. If the Rule-Mate level sensor becomes fouled by debris or contaminated water, its unique back-up feature will prevent the pump from entering a run-on condition, protecting the battery while maintaining automatic operation.

• Higher Flow: Optimized Impeller To Provide Up To 10Percent More Flow At The Same Amperage As Previous Models With Capacities From 500 To 2000 GPH
• Auto Sense Intelligence: Integral Water Level Sensor Controls The Pump Automatically
• Back Up Feature: Prevents Continuous Running If Sensor Is Fouled By Debris, Pump Reverts To 2.5 Minute Cycle Mode
• Smaller Footprint: 2/3 The Size Of Previous Models
• Built-In Thermal Cut-Off: Provides Added Protection For Pump And Vessel
• Back Flow Prevention: Reduces The Amount Of Water Left Over In The Bilge, Reducing Odor And Helping Keep Your Bilge Cleaner
• Hidden Air Vents In The Body: Helps Prevent Air Locking In Challenging Plumbing Installations And Helps With The Check Valve
• Threaded Discharge: Easier Installation, Easier Maintenance
• No Supplier Warranty